H2O Audio iDive 300 Instruction Manual download pdf (Page 4)

Quickstart: Instructions:

I. Read “Getting Familiar with the iDive 300”

II. Unlock and open case

III. Install batteries (3 AA)

IV. Install iPod speciﬁ c inserts and height adjusters (see page 10 for ﬁ t chart)

V. Install iPod

VI. Turn on iPod

VII. Close and lock Case

VIII. Press and hold the power button on the iDive300 case

(Green LED should light on back of case)

I. Getting Familiar with the iDive300

Before using the iDive300 for the ﬁ rst time, it is highly recommended that you become familiar with

opening and closing the case to ensure the case is sealed properly during use. To verify that you have

sealed the case properly we recommend that you test the product without an iPod inside before initial use.

Please follow the instructions below:

1. Read the iDive300 instruction manual to familiarize yourself with the product.

2. Unlock and open the case (see page 6) and verify the blue O-ring is clean and free of debris.

3. Close and lock the case (see page 7).

4. Immerse the case (without an iPod inside) in water and soak for 30 min.

5. Manipulate the iDive300 controls during submersion.

6. Remove from the water and dry the exterior. Visually inspect the case for any sign of leaks before

opening.

Call H2O Customer Service if you have any questions or concerns.

II. The O-ring

The removable, blue O-ring retained in the lid of the iDive300 is what keeps your iPod safe and dry.

The supplied silicone grease helps ensure the O-ring will not twist or become dislodged when closing or

opening the case. Lubricating the O-ring does not improve the seal and only a small amount of silicone

grease is necessary to lubricate the O-ring. Use only the silicone grease provided to lubricate the O-ring.

1 2 3 4 5 6 7 8 9 ... 13 14

No comments

H2O Audio iDive 300 Instruction Manual Page 4